|
| |
TM 11-5820-890-30-5
15-28.
Tools:
REPLACEMENT OF TERMINAL LUGS.
Heat sink
Cross tip screwdriver
Soldering kit
Long nose pliers
Soldering aid
Expendable Supplies:
Solder
Alcohol
Cotton swabs
References:
Paragraph 15-20 for removal and installation of mounting plate assembly.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
assembly (2)
b. Battery tray
subassembly (1)
c. Terminal lug (3) wire(s)
d. Screw, flat washer, and
Iockwasher
e. Terminal lug (3)
INSTALLATION
f.
g.
h.
i.
Terminal lug (3)
Screw, flat washer, and
Iockwasher
Terminal lug (3) wire (s)
Mounting plate
assembly (2)
Remove and retain.
Set upside down on work surface with
left side toward you.
Tag the wire (s). Use long nose pliers
and soldering equipment. Desolder
tagged wire(s) from terminal lug. See
figure 15-6.
Use cross tip screwdriver. Remove and
inspect screw, flat washer, and lock-
washer securing terminal lug (3) to
chassis. If damaged, obtain replacement.
Remove and discard.
Obtain replacement terminal lug.
Use cross tip screwdriver. Install
retained screw, flat washer, and
Iockwasher securing terminal lug
(3) to chassis.
Use long nose pliers and soldering equip-
ment. Attach and solder tagged wire (s)
to terminal lug, and remove wire tags.
Install retained mounting plate assembly
on battery tray subassembly (1).
Refer to paragraph 15-20
for removal of mounting
plate assembly.
These were removed in
step d.
Before and after soldering,
clean wires and terminal
lugs with alcohol and cotton
swabs.
Refer to paragraph 15-20
for installation of mounting
plate assembly.
15-31
|
