|
| |
TM 11-5820-890-30-5
14-40. REPLACEMENT OF POWER SUPPLY ADAPTER CHASSIS ASSEMBLY. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
l.
Binding post (5) wires
m. Two hex nuts,
Iockwashers, flat
washers, and
nylon washers
n.
Binding posts (5)
o.
Light lens
p.
Lamp
Use soldering kit, soldering aid, and
heat sink. Tag location of all wires
soldered to terminals of the E1 and E2
binding posts. Unsolder each wire from
the terminals.
Use 5/16 inch wrench. Remove and
inspect two hex nuts, flat washers, and
nylon washers securing binding posts on
the chassis.
If damaged, obtain
replacement. Discard Iockwashers.
Remove and retain.
Remove light lens from DS1 lamp holder
(6) and inspect for damage. If damaged,
obtain replacement.
Remove lamp from DS1 lamp holder (6)
and inspect for damage. If damaged,
obtain replacement.
q.
Lamp holder (6) wires
Use soldering kit, soldering aid, and
heat sink. Tag location of all wires
soldered to terminals of the lamp holder.
Unsolder each wire from the terminals.
r.
Hex nut and
Use 9/16 inch wrench. Remove and
Iockwasher
inspect hex nut securing lamp holder
on the chassis.
If damaged, obtain
replacement. Discard Iockwasher.
s.
Lamp holder (6)
Remove and retain.
t.
Circuit breaker (7)
Use soldering kit, soldering aid, and heat
wires
sink. Tag location of all wires soldered
to CB1 circuit breaker terminals. Unsolder
each wire from the circuit breaker.
u.
Hex nut, switch plate,
and lock ring
Use adjustable wrench. Note orientation
of circuit breaker. Remove and inspect
hex nut, switch plate, and lock ring
securing circuit breaker on the chassis.
If damaged, obtain replacement.
v.
Circuit breaker (7)
Remove and retain.
14-66
|
