14-26. REPLACEMENT OF LCL/RMT ROTARY SWITCH (8A2S1). Continued
Switch (2) wires
Rear access cover
l. 12 captive
Use soldering kit, soldering aid, and
heat sink. Solder tagged wires to
correct connections on the switch,
and remove wire tags.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power
supply adapter chassis. Use torque
screwdriver. Torque to 9 in-lb.
Before and after soldering,
clean wires and switch
connections with alcohol
and cotton swabs.
Figure 14-5. Power Supply Adapter (Rear View) Without Rear Access Cover.