|
| |
TM 11-5820-890-30-5
14-23. REPLACEMENT OF P1 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h.
i.
j.
k.
l.
Connector (9)
Connector (9) and
connector retaining
plate (11)
Four screws (10)
Connector (9) wires
Rear access cover (2)
o. 12 captive
screws (3)
Obtain replacement connector.
Position replacement connector and
retained connector retaining plate in
rear access cover.
Apply sealing compound to threads of
four retained screws. Use flat tip screwdriver.
Install and hand tighten four screws
securing the connector to the rear access
cover. Use torque screwdriver.
Torque to 90 in-lb.
Use soldering kit, soldering aid, and
heat sink. Solder tagged wires to
correct connector pins, and remove
wire tags.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power supply
adapter chassis. Use torque screwdriver.
Torque to 9 in-lb.
Before and after soldering,
clean wires and connector
pins with alcohol
cotton swabs.
and
14-38
|
