|
| |
TM 11-5820-890-30-5
8-23. REPLACEMENT
Tools:
Pocket knife
Expendable Supplies:
Adhesive
OF PLASTIC STRIP.
ITEM
ACTION
REMARKS
REMOVAL
a. Two battery box cover
Release two twist lock latches securing
latches (32)
battery box cover (1) to battery box
case (15). See figure 8-3.
b. Battery box cover (1)
Position cover to allow access to plastic
strip (10).
c. Battery box case (15)
Use pocket knife. Remove plastic strip
from case.
d. Plastic strip (10)
Discard.
INSTALLATION
e. Plastic strip (10)
Obtain replacement and apply adhesive
to back of plastic strip.
f.
Battery box case (15)
Install plastic strip in case.
g. Battery box cover (1)
Position battery box cover on case,
h. Two battery box cover
Fasten two twist lock latches securing
latches (32)
battery box cover to case.
8-24. REPLACEMENT OF BATTERY BOX CASE.
Tools:
Cross tip screwdriver
Flat tip screwdriver
Heat sink
Soldering kit
Soldering aid
Torque screwdriver
Expendable Supplies:
Cotton swabs
Solder
Alcohol
References:
Paragraph 8-14 for removal and installation of catch assemblies.
Paragraph 8-18 for removal and installation of J1 connector.
Paragraph 8-20 for removal and installation of seal screws.
Paragraph 8-23 for removal and installation of plastic strip.
ITEM
ACTION
REMARKS
REMOVAL
a. Two battery box cover
Release two twist lock latches securing bat-
Iatches (32)
tery box cover (1) to battery box case (15).
8-19
|
