|
| |
TM 11-5820-890-30-5
8-14. REPLACEMENT OF CATCH ASSEMBLY. Continued
ITEM
ACTION
REMARKS
INSTALLATION
c. Catch assembly (18)
Position replacement catch to battery box
case (15).
NOTE
d. Two screws (11), flat
Use cross tip screwdriver. Install two re-
Do not over tighten
washers (13), and lock-
tained screws, flat washers, and lock-
screws.
washers (12)
washers securing catch (18) to battery
box case (15).
8-15. REPLACEMENT OF TWO-WIRE TRANSIENT PROTECTION CCA.
Tools:
Soldering kit
Cross tip screwdriver
Soldering aid
Flat tip screwdriver
Heat sink
Torque screwdriver
Expendable Supplies:
Solder
Alcohol
Cotton swabs
ITEM
ACTION
REMARKS
REMOVAL
a.
b.
c.
d. Bus wires
e.
f.
g.
Five captive screws (31)
Use flat tip screwdriver. Fully loosen
five captive screws securing access
cover (27) to battery box case (15).
Access cover (27)
Pull access cover away from battery box
case (15) to allow resoldering of wires.
Wires
Use soldering kit. Tag and desolder
wires from defective two-wire transient
protection CCA terminals E1 thru E3.
Use soldering kit. Desolder two bus wires
from two-wire transient protection CCA
(26) and binding posts (28).
Remove and retain.
Four screws (9), flat
Use cross tip screwdriver. Remove and
washers (7), and lock-
retain four screws, flat washers, and lock-
washers (8)
washers securing two-wire transient pro-
tection CCA (26) to battery box access
cover (27).
Access cover (27)
Retain.
Two-wire transient
Remove and discard.
protection CCA (26)
8-11
|
