|
| |
TM 11-5820-890-30-5
4-67. REPLACEMENT OF SIDE PANEL. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h. Side panel (1)
i.
Shoulder pin (6)
Position replacement side panel (1) to
power control chassis (8). Using cross
tip screwdriver, install four retained
screws (2) securing replacement side
panel (1) to power control chassis (8).
Position retained shoulder pin (6), hex nut
(5), Iockwasher, and flat washer to side
panel (1). Using adjustable wrench and
1/2-inch open-end wrench, tighten nut.
j.
J1 protective cap (29)
Using cross tip screwdriver, install retained
screw (7) and flat washer securing
retained J1 protective cap (29) to side
panel (1).
k. Mounting rail (4)
Using cross tip screwdriver, install seven
retained screws (3) securing retained
mounting rail (4) to side panel (1).
1.
Nine screws (7 and 8)
Using cross tip screwdriver, install nine
retained screws (7 and 8) securing top
shelf (9) to mounting adapter.
m. Two screws (5)
Using cross tip screwdriver, install two
retained screws (5) securing side panel
(6) to power supply chassis (15).
See figure 4-19.
These were removed in
step g.
These were removed in
step f.
These were removed in
step e.
These were removed in
step d.
See figure 4-20.
These were removed in
step c.
These were removed in
step b.
4-183
|
