|
| |
TM 11-5820-890-30-5
3-28. REPLACEMENT
Tools:
Soldering kit
Expendable supplies:
Alcohol
References:
OF TEST POINTS AND POWER PLUGS.
1-1/32-inch nutdriver
Cotton swabs
Paragraph 3-25 for removal and installation of test adapter
Figure 3-12 for illustration of test points and power plugs.
Solder
from maintenance group lid.
ITEM
ACTION
REMARKS
REMOVAL
a. Wires
b. Hex nut and washer
c. Test point or power plug
(39 thru 44, or 24 or 25)
INSTALLATION
d. Test point or power plug
(39 thru 44, or 24 or 25)
e. Hex nut and washer
f. Wires
Using soldering kit, desolder wires from
See figure 3-12
test point TP1 thru TP12 (39 thru 44) or
(sheets 1 and 2).
power plug J15 or J16 (24 or 25).
Using 1-1/32-inch nutdriver, remove and
retain hex nut and washer securing test
point or power plug to test adapter.
Remove and discard defective test point
or power plug.
Insert replacement test point or power
plug into test adapter.
Using 1-1/32-inch nutdriver, install and
These were removed in
tighten retained washer and hex nut on
step b.
test point (39 thru 44) or power plug
(24 or 25) securing it to front panel.
Using soldering kit, solder wires on test
Before and after soldering,
point or power plug.
clean solder joints with
cotton swabs and alcohol.
3-98
|
