|
| |
TM 11-5820-890-30-5
2-1.
INTRODUCTION. Continued
The power supply converts the dc input voltage into the voltages required by the other modules in the RT. It is
described in paragraph 2-5.
The RT chassis includes:
The front panel with its switches, controls, connectors, and displays.
The module interconnections.
Frame for physical support of the modules.
System, battery, and COMSEC connectors.
It is described in paragraph 2-6.
A description of the types of signals present in the RT is included in paragraph 2-7.
Paragraphs 2-8 through 2-21 provide functional description of the RT in different modes of operation.
2-2.
CONTROL SECTION.
The control section consists of five modules. They are:
Electronic Components Assembly - Control 1A4 (control module).
Control, Counter-Countermeasures - Electronic 1A5 (ECCM module).
Circuit Card Assembly - Remote I/O 1A2 (remote l/O module).
Circuit Card Assembly - Two-Wire Interface 1A6 (two-wire interface).
Circuit Card Assembly - Switch 1A7 (switching module).
The module locations are shown in figure 2-3.
Figure 2-3. Control Section Module Locations
2-4
|
