|
| |
TM 11-5820-890-30-5
2-49. REPLACEMENT OF RT FRONT PANEL
Tools:
Cross tip screwdriver
Torque screwdriver
Round nose pliers
Expendable supplies:
Silicone compound
References:
ASSEMBLY.
Flat tip screwdriver
Module extractor
Paragraph 2-35 for removal and installation of
Paragraph 2-37 for removal and installation of
Paragraph 2-47 for removal and installation of
Paragraph 2-50 for removal and installation of
Paragraph 2-51 for removal and installation of
Paragraph 2-52 for removal and installation of
RT covers.
impedance matching network.
data entry keyboard.
display circuit card assembly.
audio flex assembly.
switch flex assembly.
ITEM
ACTION
REMARKS
REMOVAL
a. RT top cover
Remove and retain.
b. RT bottom cover
Remove and retain.
c. Impedance matching
Remove and retain.
network
d. Data entry keyboard
Remove and retain.
f. Left bow handle
g. Four screws
h. Guard assembly
i.
Nine captive screws
e. Four screws
Use cross tip screwdriver. Remove and re-
tain four screws securing left bow handle
to RT chassis.
Remove and retain.
Use cross tip screwdriver. Remove and re-
tain four screws securing guard assembly
to RT chassis.
Remove and retain.
Use flat tip screwdriver. Fully loosen nine
captive screws securing RT front panel
assembly to RT chassis.
CAUTION
Refer to paragraph 2-35 for
removal of top cover.
Refer to paragraph 2-35 for
removal of bottom cover.
Refer to paragraph 2-37 for
removal of impedance
matching network.
Refer to paragraph 2-47 for
removal of data entry key-
board.
Be careful not to catch RF cable W1 on RT chassis obstructions.
j.
RT front panel assembly
Pull RT front panel assembly free of RT
chassis and place RT front panel face
down on work surface.
2-177
|
