|
| |
TM 11-5820-890-30-5
2-38. REPLACEMENT OF POWER SUPPLY (1A3).
Tools:
Flat tip screwdriver
Module extractor
Torque screwdriver
References:
Paragraph 2-34 for use of module extractor.
Paragraph 2-35 for removal and installation of RT covers.
Figure 2-15 for module locations.
Figure 2-16 for screw locations.
ITEM
ACTION
REMARKS
REMOVAL
a. RT bottom cover
b. Two screws
c. RT top cover
d. Power supply
INSTALLATION
e. Power supply
f. Two screws
g.
RT bottom cover
h. RT top cover
Remove.
Refer to paragraph 2-35 for
removal of bottom cover.
Use flat tip screwdriver. Remove and re-
See figure 2-16 for screw
tain two screws securing power supply.
locations.
Remove.
Refer to paragraph 2-35 for
removal of top cover.
Using module extractor, remove from RT.
Refer to paragraph 2-34 for
use of module extractor.
See figure 2-15 for module
location.
Check connector location and insert power
supply. Press down to seat fully.
Use flat tip screwdriver. Install two retained These were removed in
screws.
step b.
Install.
Refer to paragraph 2-35
for installation of bottom
cover.
Refer to paragraph 2-35 for
installation of top cover.
Install.
2-163
|
