Chapter 2. INSTALLATION - TM-11-5820-815-140029

TO 31R2-2GRC171-2

TM 11-5820-815-14

NAVELEX 0967-LP-544-5010

CHAPTER 2

INSTALLATION

INTRODUCTION

This chapter provides the information necessary for the

taining to receiving and unpacking the equipment, and

installation of Radio Set AN/GRC-171. Section I,

section III provides instructions for installing and

installation planning, briefly describes installation

checking the equipment. Instructions for reshipment of

considerations. Section II contains logistic data per-

the equipment are provided in section IV.

SECTION I

INSTALLATION PLANNING

2-5. Radio Set Control C-7999/GRC-171 requires a 82.6-

2-1. GENERAL.

mm (3.25-in) by 66.7-mm (2.62-in) mounting space for

the front panel with approximately 152.4-mm (6.00-in)

2-2. There are no special instructions required for

front-to-rear clearance to allow for the unit and the

installation planning. A discussion of mounting and

mating connector. The unit is mounted with four screws,

cabling follows.

one in each corner of the front panel.

2-3. MOUNTING.

2-6. CABLING.

2-4. Radio Receiver-Transmitter RT-980/GRC-171

2-7. A cable interface kit is supplied with Radio Set

mounts on slides in a standard482.6-mm (19-in) rack.

AN/GRC-171. The kit contains mating multiple pin

The unit requires 222.3 mm (8.75 in) of vertical

connectors for the receiver-transmitter and the control

clearance and 546.1 mm (21.50 in) of front-to-rear

units. The interconnecting wiring is supplied by the user.

clearance. Rack slides are included in the slide mounting

The maximum wire length between RT-980/GRC-171

hardware kit.

and C-7999/GRC-171 is 305 m (1000 ft). Refer to figure

2-1/(2-2 blank)