 |
|||
|
|
|||
|
Page Title:
Temporarily install mounting weldment |
|
||
| ||||||||||
|
|  TB 9-2320-387-35-2
18-27. Temporarily install mounting weldment (47) at holes 14 (51) and 15 (52) from top of rear
support legs (43). Secure mounting weldment (47) to rear support legs (43) with four
capscrews (53), eight washers (46), and four locknuts (54). Tighten locknuts (54) enough to secure
mounting weldment (47) to rear support legs (43).
18-28. Align rear flange of mounting weldment (47) with left-rear wheelhouse half-section (49), and locate
and mark two holes. Use center of slotted holes (50).
18-29. Remove four locknuts (54), eight washers (46), four capscrews (53), and mounting weldment (47)
from rear support legs (43).
18-30. Drill two 0.391-in. diameter holes on left-rear wheelhouse half-section (49).
18-31. Install two inserts (48) in left-rear wheelhouse half-section (49).
18-32. Install mounting weldment (47) on rear support legs (43) at holes 14 (51) and 15 (52) from top with
four capscrews (53), eight washers (46), and four locknuts (54). Do not tighten locknuts (54) at this
time.
18-33. Secure rear flange of mounting weldment (47) to left-rear wheelhouse half-section (49) with two
screws (44), lockwashers (45), and washers (46). Do not tighten screws (44) at this time.
43
54
45
44
46
46
47
48
46
53
49
50
46
53
51
44.
SCREW MS3507-306 QTY. 2
45.
LOCKWASHER MS35338-139 QTY. 2
52
46.
WASHER MS15795-810 QTY. 10
47.
MOUNTING WELDMENT A3265775 QTY. 1
48.
INSERT MS51967-3 QTY. 2
53.
CAPSCREW B1821BH025C175N QTY. 4
54.
LOCKNUT MS35649-2254 QTY. 4
Figure 5-84.
Change 1
5-63
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals