Quantcast Section V. ASSEMBLY OF CAB ENCLOSURE PANEL - TB-9-2320-387-35-20030

 

Click here to make tpub.com your Home Page

Page Title: Section V. ASSEMBLY OF CAB ENCLOSURE PANEL
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Section IV. B-BEAM PREPARATION - TB-9-2320-387-35-20029
Up
TB-9-2320-387-35-2 Single Channel Ground and Airborne Radio System (SINCGARS) AN/VRC-88F AN/VRC-89F AN/VRC-90F AN/VRC-91F AN/VRC-92F Manual
Next
Install 24V terminal board - TB-9-2320-387-35-20031


TB 9-2320-387-35-2
Section V. ASSEMBLY OF CAB ENCLOSURE PANEL
NOTE
· For 12V terminal board installation on models with rifle mount
bracket shown in figure 5-8, perform steps 5-1 through 5-3.
· If not installing 12V terminal board, begin with step 5-4.
5-1. Remove lower rifle mount bracket (1) from B-beam. (Refer to TM 9-2320-387-24.)
5-2. Locate, mark, and drill two 0.159-in. diameter holes marked A in lower rifle mount bracket (1) and
install 12V terminal board (4) with two screws (2), lockwashers (3), and nuts (5).
5-3. Install lower rifle mount bracket (1) on B-beam. (Refer to TM 9-2320-387-24.)
2
3
4
5
1.35
1.50
A
1
3.00
A
2. SCREW ­ MS35206-230 ­ QTY. 2
3. LOCKWASHER ­ MS35338-41 ­ QTY. 2
5. NUT­ MS35649-63 ­ QTY. 2


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.