EXPLANATION OF TABLE ENTRIES.

TB 11-5820-890-12

2-5.

EXPLANATION OF TABLE ENTRIES.

Item Number. Numbers in this column are for reference. When completing DA Form 2404 (Equipment

Inspection and Maintenance Worksheet) include the item number for the check/service indicating a fault. Item

numbers also appear in the order you must do checks and services for the intervals listed.

Interval Column. This column tells you when you must do the procedure in the procedure column.

(1)

BEFORE procedures must be done before you operate or use the equipment for its intended mission.

(2)

DURING procedures must be done during the time you are operating or using the equipment for its

intended mission.

(3)

AFTER procedures must be done immediately after the time you have operated or used the

equipment.

(4)

WEEKLY procedures must be done once a week.

Location, Check/Service Column. This column provides the location and the item to be checked or serviced.

The item location is underlined.

Procedure Column. This column gives the procedure you must do to check or service the item listed in the

Check/Service column to know if the equipment is ready or available for its intended mission or for operation.

You must do the procedure at the time stated in the interval column.

Not Fully Mission Capable If: Column. Information in this column tells you what faults will keep your equipment

from being capable of performing its primary mission. If you make check and service procedures that show

faults listed in this column, do not operate the equipment. Follow standard operating procedures for maintaining

the equipment or reporting equipment failure.

NOTE

Be sure to observe all special information and notes that appear in your table.

If your ANCD is not working, refer to Paragraph 3-2 for operator troubleshooting procedures, for possible

solutions. Report any problems or failures on DA Form 2404. If need be, refer to DA PAM 738-750.

2-7