Equipment Setup/Operation

TM 11-5820-890-10-10

Equipment Setup/Operation. Assemble and install the radio set and DMD individually per applicable

technical manuals. Perform Preventive Maintenance Checks and Services (PMCS) and/or Built-In-Test

(BIT) functions. Load all frequencies, hopsets, and variables into the radio set and establish voice

communications before connecting the DMD to the radio set. Once voice communication has been

established, connect the DMD as described in the following paragraph.

5 . C a b l i n g I n s t r u c t i o n s . The following figure illustrates the typical configuration for the connection between

the radio set and the DMD.

Connect interface cable CX-13308 from DMD FSK connector to RT AUD/DATA connector.

Figure shows the DMD connected to lower radio (RT-A).

DMD may be connected to upper radio (RT-B) if desired.

NOTE

T h e interface cable CX-13308 must be used. It is identified in the SINCGARS AAL as

National Stock Number 5995-01-303-0308. This cable replaces the existing DMD FSK

cable.

F i g u r e 1. Cabling for DMD to SINCGARS Radio Set